CCPQD - JA-273, 500

  • MSDS: CCPQD
  • Manufacturer: POLYTECH
  • Product Name: JA-273, 500
  • National Stock Number: 6630-00N054766
Product Identification

Product ID:JA-273, 500
MSDS Date:06/16/1994
FSC:6630
NIIN:00N054766
MSDS Number: CCPQD

Responsible Party
POLYTECH
2520 SAN FERNANDO RD
LOS ANGELES, CA 90065
US

Emergency Phone: 800-255-3924

Info Phone: 800-421-9402

Cage: 0FWB4

Contractor
POLYTECH
LOS ANGELES, CA 90065 US

Telephone: 213-223-3232/800-421-9402

Cage: 0FWB4

Ingredients

DISTILLATES (PETROLEUM), HYDROTREATED MIDDLE;

CAS: 64742-46-7

RTECS: JN9379645

Fraction By Weight: 80-100%

OSHA PEL 200 PPM (MFR)

ACGIH TLV: 200 PPM (MFR)


MINERAL OIL, WHITE; (TECHNICAL WHITE MINERAL OIL)

CAS: 8042-47-5

RTECS: PY8047000

Fraction By Weight: 1-5%

OSHA PEL N/K

ACGIH TLV: N/K


ETHYLENE, TETRAFLUORO-, POLYMER; (POLYTETRAFLUOROETHYLENE)

CAS: 116-14-3

RTECS: KX4025000

Fraction By Weight: TRACE

OSHA PEL 10 MG/M3 (MFR)

ACGIH TLV: 10 MG/M3 (MFR)


CARBON DIOXIDE; (CARBON DIOXIDE PROPELLANT)

CAS: 124-38-9

RTECS: FF6400000

Fraction By Weight: 1-5%

OSHA PEL 5000 PPM

ACGIH TLV: 5000 PPM; 30000 STEL

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES: MAY CAUSE SLIGHT IRRITATION BUT
DOES NOT INJURE EYE TISSUE. SKIN: FREQUENT OR PROLONGED CONTACT MAY
CAUSE IRRITATION. INHALATION: INHALATION OF MIST CAN CAUSE
IRRITATION OF NASAL AND RESPIRATORY PASSAGES. ABUSIVE OR EXCESSIVE
INHALATION MAY CAUSE IRRITATION TO THE UPPER RESPIRATORY TRACT,
(EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ: DIZZINESS, NAUSEA AND OTHER CENTRAL
NERVOUS SYSTEM EFFECTS. INGESTION: CAN CAUSE GASTROINTESTINAL
IRRITATION, NAUSEA, VOMITING AND DIARRHEA. ASPIRATION OF MATERIAL
INTO THE LUNGS CAN CAUSE C HEMICAL PNEUMONITIS. MINIMAL TOXICITY.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid

First Aid:EYES: FLUSH W/LARGE AMOUNTS OF COOL RUNNING WATER FOR AT
LEAST 15 MINUTES WHILE HOLDING UPPER & LOWER LIDS OPEN. IF IRRIT
PERSISTS GET MED ATTENTION IMMEDIATELY. SKIN: WASH W/SOAP & WATER.
IF IRRIT PE RSISTS SEEK MED ATTENTION. INHAL: REMOVE TO FRESH AIR.
SEEK MED ATTENTION IMMEDIATELY. IF BREATHING STOPS GIVE ARTIFICIAL
RESPIRATION. INGEST: DO NOT INDUCE VOMITING. SEEK MED ATTENTION
IMMEDIATELY.

Fire Fighting

Flash Point Method:TOC
Flash Point:239F,115C
Extinguishing Media:FOAM, CARBON DIOXIDE, DRY MEDIA.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA AND FULL PROTECTIVE
EQUIPMENT . COOL FIRE EXPOSED CONTAINERS TO PREVENT RUPTURING.
Unusual Fire/Explosion Hazard:EXPOSURE TO TEMPERATURES ABOVE 120F MAY
CAUSE BURSTING.

Accidental Release

Spill Release Procedures:ALLOW PROPELLANT TO EVAPORATE. MAINTAIN LOCAL
EXHAUST & ADEQUATE VENTILATION. NO SMOKING. KEEP SPARKS, HEAT
SOURCES & OPEN FLAME FAR AWAY FROM SPILL OR LEAK. COVER W/ABSORBENT
MATERIAL & SWEEP UP. WAS H AREA TO PREVENT SLIPPING. DISPOSE OF
(SUPDAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:STORE IN A COOL, DRY AREA AWAY FROM
HEAT OR OPEN FLAME. DO NOT STORE AT TEMPERATURES ABOVE 120F. NFPA
CODE 30B RATING: LEVEL 3 AEROSOL.
Other Precautions:KEEP OUT OF THE REACH OF CHILDREN. FOR INDUSTRIAL AND
INSTITUTIONAL USE ONLY.

Exposure Controls

Respiratory Protection:NONE NEEDED FOR PROPER USE IN ACCORDANCE WITH
LABEL DIRECTIONS. USE NIOSH APPROVED RESPIRATOR APPROPRIATE FOR
EXPOSURE OF CONCERN .
Ventilation:PROVIDE LOCAL EXHAUST TO KEEP TLV OF LISTED INGREDIENTS
BELOW ACCEPTABLE LIMITS.
Protective Gloves:CHEMICAL RESISTANT GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPROVED EYE WASH & DELUGE SHOWER .
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
SPILL PROC: SOAKED ABSORBENT MATERIAL I/A/W FEDERAL, STATE & LOCAL
LAWS.

Chemical Properties

Boiling Pt:B.P. Text:300F,149C
Vapor Pres:90 PSIG
Vapor Density:>1
Spec Gravity:0.810 (H*2O=1)
Solubility in Water:SLIGHT
Appearance and Odor:CLEAR BROWN LIQUID; SOLVENT ODOR.

Stability

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:CARBON DIOXIDE, CARBON MONOXIDE.

Disposal

Waste Disposal Methods:AEROSOL CANS, WHEN EMPTIED AND DEPRESSURIZED
THROUGH NORMAL USE, POSE NO DISPOSAL HAZARD AND SHOULD BE RECYCLED.
CONSULT FEDERAL, STATE AND LOCAL AUTHORITIES FOR APPROVED
PROCEDURES.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.